Subject | Text |
tv graetz 2897 | Hy
i have vertical line
power suplay is o.k
electrolits capacitors replaysed
ta8427k also replas |
It works! | Thanks! i replaced the vertical output and any caps in the vertical sectin. And of course any leak |
|
Nad MR 13 TV | The picture on the screen is not round anymore but on the alph of the top is vertical elongate.
How |
| It sounds like a verticle deflection problem. You can try replacing the verticle output IC and assoc |
Re: tv panasonic 29" and 34" | [quote:311fa48ba0="donokncr"]Hi there.I need several information for modified of deflection yoke typ |
Zenith | About 2/3rds of the sets that come into my shop are Zeniths that were manufactured in the early to l |
Jvc Tv,AV-14FMG3B is not having picture & sound, power i | It is unlikely to be the timer causing any problems but the timer can be reset simply by swithing "o |
Re: looking for | That's the "Location" and "Rating/Value" of [b:4805c014b2]a part[/b:4805c014b2] |
jvc av36950/no picture good sound good tunerhelp please!!!!! | I have a 36 inch jvc tv I bought in ninty eight its been perfect. Until wife was watching tv one nig |
| Hi Mark,
Thanks for your advice. I checked all the power resistors for the value and replaced the |
| Try replacing your vertical IC. |
dry joints | Check for dry solder joints in the Horizontal and Vertical deflection circuit, I had the same proble |
Problem with Samsung CS761 Chassis SCT55A | The TV switch on but no picture or sound. I assume the deflection circuits work because the OSD work |
| here is the color codes:
PIN LABEL FUNCTION COLOR
1 RED Red color signal pink
2 GREEN Green co |
@Guest | @guest who recommends to replace all caps of the vertical driver unit
Okay, I agree that might be t |
MITSUBIBHI SHUTDOWN | HELLO. Well KIKI the first thing that comes to mind is even though the tubes were replaced there had |
| There's a kit, Deflection PWB Repair Kit X480315. It has you replace Q777 the H out, pico E947 and t |
|
Searching for LA7845N solution in EURAS | Please help me, I'm searching a solution to the problem that occurs in my Samsung crt tv with chassi |
MONITOR SCHEMATIC SAMTRON 45B (DP14LT7L/ING) | I WANT SCHEMATIC FOR SAMTRON 45B (DP14LT7L/ING)
VERTICAL OUT IC USED TDA 9302H |
Samsung ps-42s4s problem ! | Samsung
Model.no PS-42S4S
can i solve this problem?
it's have vertical lines on the screen
|
oscilloscope HP 1720A need service schematic manual | I have a Hp 1720A oscilloscope that has lost the vitical deflection. due to power supply problem. Th |
hope not | 4 years still young for a tv, i can still get parts for a 10 year old tv. do you have schema for you |
| Or you may have the Vertical deflection IC damaged.
But probally not since you opened the TV that |
Sony KP-53V75 Projector Convergence Problem? | Hi,
My projector have started to act a bit weird.. On the right edge side of the tv screen, the p |
| Try the vertical output IC Might be bad or just poor solder connections. It is IC 401. Also check I |
Need resistor value for SHARP TV Model 21A2-S | HI DUDE..
Please help me,i need value resistor location R509 (near vertical ic=burn)
for SHARP TV |
To (maybe) clarify what LJ told you | All this assumes you have some means of measuring resistance and voltage. How much experience desold |
| that problem is replace (??tda48xx??) autosync deflection
IC controller check 5v and 12v! voltage |
JVC AV-48WP55 | hello,
Your tv had at first a serious overload,caused by a sort circuit in one of the horizontal or |
| This is what I know.
# Continuous Blinking: Not getting reply from IC301 Jungle IC, Bad "IK" video |